SSZ SSZ-BAT, System Manual, Page: 4 / 66

4
About these operating instructions
2. Safety instructions
n
Do not modify the control unit
n
Check supply voltage
Supply volatge must correspond with the connecting voltage on the label.
n
Protect from sunlight
Protect from direct sunlight and from heat sources.
n
Observe pin assignment
When connecting the supply voltage.
n
Fit spark absorbers
When connecting inductive loads, fit spark absorbers (RC modules) to the user.
n
Do not cross link control unit with other control units
n
Do not overload control unit
Ensure that the specified switching current is not exceeded.
n
In the event of fault put out of operation
In case of malfunctions and visible damage, put the control unit out of operation.
n
Do not use in EX zones
Do not use the control units in potentially explosive environments (ATEX). The control unit
is not authorized for using in these zones
n
Installation: danger of injury due to electrocution!
Disconnect all devices and live parts in the immediate environment from the power supply
and protect them against being switched on again (see relevant operating instructions)
Check whether all devices and parts are disconnected from the power supply
n
Installation: impaired operation due to overheating
The operation of the protective device may be impaired due to overheating of the control
unit.