
Hardware Reference Guide
SST-PFB3-PCI
4.1 SYS LED is Red
If the SYS LED is red, the card is not running or there’s been a firmware run-time error. Check the WdTout bit for a
timeout, and consult the appropriate firmware manual if necessary. If you continue to experience difficulties, contact
technical support (refer to Section D.3,
Technical Support
, for details).
Note
For information on LED flash codes, refer to Section A.3,
Fatal Hardware Self-Test
Flash Codes
.
32
Troubleshooting
©2003 Woodhead Software and Electronics, a division of Woodhead Canada Limited.
Document Edition: 1.0, Document #: 715-0060, Template Edition: 1.0, Template #: QMS-06-045.
Use, duplication or disclosure of this document or any of the information contained herein is subject to the restrictions on page ii of this document.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com