Hardware Reference Guide
SST-PFB3-PCI
1.4.1 LEDs
There are two LEDs on the card: communications (COMM), and system (SYS). The LEDs are identified in the
following figure.
Figure 2: Card Bracket
SYS LED
COMM LED
During power-up, the COMM LED is
off
, and the SYS LED is
amber
. Once a module has been loaded, the LEDs
are under firmware control. Refer to the firmware reference guide for more details.
If, during power-up, a fault is detected by the boot code, an error is flashed on the SYS LED. Refer to Section A.3,
Fatal Hardware Self-Test Flash Codes
, for more details.
Note
For information on troubleshooting using LEDs, refer to Section 4.1,
SYS LED is Red
.
16
Card
Overview
©2003 Woodhead Software and Electronics, a division of Woodhead Canada Limited.
Document Edition: 1.0, Document #: 715-0060, Template Edition: 1.0, Template #: QMS-06-045.
Use, duplication or disclosure of this document or any of the information contained herein is subject to the restrictions on page ii of this document.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com