20
Lower Leg Assembly
Position the fork at an angle with the bolt holes oriented upward.
Position the fork at an angle with the bolt holes oriented upward.
Inject suspension oil into each lower leg through the bottom bolt holes.
Inject suspension oil into each lower leg through the bottom bolt holes.
Consult the
Consult the
DebonAir Upgrade, Travel Change, and Bottomless Token
DebonAir Upgrade, Travel Change, and Bottomless Token
section for fork oil volumes.
section for fork oil volumes.
Use the oil weight and volume for your
Use the oil weight and volume for your
fork model and year.
fork model and year.
NOTICE
Do not exceed the recommended oil volume per leg as this can
damage the fork.
Slide the lower leg assembly along the upper tubes until it stops and
the spring and damper shafts are visible through the lower leg bolt
holes.
Use a shop towel to clean all excess oil from the outer surface of the
lower leg.
Thread the black bottom bolt into the non-drive side lower leg. Thread
the silver bottom bolt into the drive side shaft of the lower leg.
Use a torque wrench with a 5 mm hex bit socket to tighten the bolts to
7.3 N·m (65 in-lb).
Install the rebound adjuster knob onto the rebound damper bottom
bolt.
Use a torque wrench with a 2.5 mm hex bit socket to tighten the set
screw to 0.9 N·m (8 in-lb).
NOTICE
Hold the rebound adjuster knob in place during installation to
prevent damage to the bottom bolt.
4
Maxima PLUSH Dynamic Suspension Lube Light
RockShox Bleed Syringe
5
6
5 mm
7.3 N·m (65 in-lb)
5 mm
7.3 N·m (65 in-lb)
7
2.5 mm
0.9 N·m (8 in-lb)
