PIR Sensor LED Flashes/Does not Flash
When in operation the LED will not flash or it will only flash for a short time. Remember
the aim is to keep the Spydercam hidden.
The Spydercam will not retain settings
Make sure that you have saved the changes that you make during the menu setup of
the camera.
If you don’t select and save these settings, the camera will revert back to the default
settings.
The Spydercam captured a video and is only showing the message ―damaged video can’t
open‖
This is normally caused by a low quality SD card. Format the card or replace it.
Irregular power off. When the batteries are low, it is recommended to first switch off
the camera, then take out the old batteries.
Sometimes the software on the Spydercam freezes
This can also be the cause of a low quality SD Card.
Restart your camera in order for the settings to be saved.
The first/last couple of images are fuzzy or too white
When you switch the Spydercam to the ON position, while mounting the device, your
hand movement will cause ―false‖ pictures to be taken.
When entering into the ON position, the device has a 15s waiting time, in the
meantime the green indicated LED will blink.
As a solution you should mount the Spydercam while it is in the OFF position. Once
finished affixing the camera, open the cover, switch to ON position, close the cover,
and leave the area within 15 seconds.
It is therefore also suggested that you approach the Spydercam from behind when
switching it OFF.
When Spydercam connected to TV, the image is unstable
This is caused by the voltage unsteadiness which relate to your local area power
supply.
Setup the Frequency, choice 50Hz or 60Hz, to correspond with your local area power
frequency.
