Pictures are blurred:
In these cases the subject moved too quickly.
Red, green or blue color cast
In certain lighting conditions, such as the period just after sunset, the sensor might
distort images.
Video Clips not recording in accordance with setting
Ensure that the SD Card memory is not full.
Check that the battery power is full. The Spydercam may record shorter video clips to
conserve power towards the end of the battery life.
Short video clips—not recording to the length set
Check to make sure that the SD card is not full.
Make sure that the camera has good batteries in it. Near the end of the battery life, the
camera may record shorter video clips to conserve power.
When IR LED is on, the pictures/videos are sometimes in black & white
This will happen if photographs are taken in poorly lit indoor areas or at dusk if taken
outdoors. This is as a result of the Spydercam’s ability to automatically sense the
brightness of the light.
If the problem persists, you just need to move the set up angle of the Spydercam
slightly.
It is also recommended not to turn on the IR LED for indoor use during the day.
Date/time Stamp not appearing on images
Make sure that the ―Time Stamp‖ setting is set to ―On‖ in the Menu.
Photos do not reflect any subjects
Check the ―Sensor Level‖ (PIR sensitivity) parameter setting. For warm
environmental conditions, set the Sensor Level to ―High‖ and for cold weather use set
the sensor to ―Low‖.
Try to set your camera up in an area where there is not a heat source in the camera’s
line of sight.
In some cases, setting the camera near water will make the camera take images with
no subject in them. Try aiming the camera over ground.
Try to avoid setting the camera up on small trees that are prone to being moved by
strong winds.
