Copyright 2012 Radiodetection Ltd.
– SPX Corporation. All rights reserved. Radiodetection is a subsidiary of SPX Corporation.
This document may not be copied, reproduced, transmitted, modified or used, in whole or in part, without the prior written consent of Radiodetection
Ltd. We reserve the right to alter or amend any published specification without notice.
Page 21 of 59
Check that the new 15mm O-ring is in
position on the terminal nut.
Slide the spring body of the sonde onto
the terminal nut, ensuring none of the
four wires is trapped by the metal work.
Slide the rod cover along the rod and
temporarily insert a M3 x 25mm
caphead screw into the side.
Loosely thread the rear cover onto the
spring body by using the caphead screw
as leverage.
Using the “C” spanner to hold the spring
body, fully tighten the rod cover onto the
spring body by using the caphead screw
as leverage.
15mm O-ring
Cap-head
screw
Notch for “C”
spanner
Rear Cover