INSTALLATION INSTRUCTIONS
Location
Window Slider kit Installation
Note: If the window opening is less than the minimum
required length and the slider kit needs to be cut down
to size, cut the piece with the hole in it, but cut the end
without the hole. Do not cut out the hole in the kit.
Fig.3
12 in
12 in
bolt
Window
slider kit
Horizontal
window
Horizontal
window
Fig.5a
Fig.4
Fig.5
The air conditioner should be placed on a rm
foundation to minimize noise and vibration. For
safe and secure positioning, place the unit on a
smooth, level oor strong enough to support the unit.
The unit has casters to aid placement, but it should
only be rolled on smooth, at surfaces. Use caution
when rolling on carpet surfaces. Do not attempt to
roll the unit over objects.
The unit must be placed within reach of a properly
rated grounded socket.
Never place any obstacles around the air inlet or
outlet of the unit.
Allow at least 12 inches of space from the wall for
efcient air-conditioning. Fig.3.
Your window slider kit has been designed to t most
standard vertical and horizontal window applications.
However, it may be necessary for you to improvise or
modify some aspects of the installation procedures for
certain types of window. Please refer to Fig 4 & 5 for
minimum and maximum window opening requirements.
Window slider kit can be xed with a bolt (Fig. 5a)
Window Slider Kit
Minimum:26.5in (2.22ft).
Maxmum:48 in (4.04ft).
Window Slider Kit
Minimum:26.5 in (2.22ft).
Maxmum:48 in (4.04ft).
6
7
INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
Installation for a double-hung sash window
Foam seal A
(adhesive type)
Foam seal
Fig.6
Fig.7
Fig.8
Fig.9
Window kit
Window stool
Window kit
Window stool
26.5 ~ 48.0
1. Trim foam seal (with adhesive) to the proper length and
attach to window stool. Fig.6.
2. Adjust the length of the slider kit according to the width
of the window. Place slider kit to window stool, on top of
foam seal. Fig.7.
3. Trim another foam seal (with adhesive) to the proper
length and place on top of the slider kit.
4. Close the window sash securely against the kit. Fig.8.
5. Trim the last foam seal to the proper length to seal the
open gap between the top window sash and outer
window sash. Fig.9.
Installation for a sliding sash window
1. Trim foam seal (with adhesive) to the proper length and
attach to window frame. Fig.10
2. Adjust the length of the slider kit according to the height
of the window. Place slider kit against foam seal. Fig.11.
3. Trim another foam seal (with adhesive) to the proper
length and attached it to the open side of the slider kit.
4. Slide window close against the kit. Fig.12
5. Trim the last foam seal to the proper length to seal the
open gap between the two window sashes. Fig.13.
Foam seal
Foam seal A
(adhesive type)
Fig.10
Fig.11
Fig.12
Fig.13
Window
panel
26.5 ~ 48.0
