50
motion unit] inch, the right space is[n2*lateral or vertical motion unit]inch.
[Note]
· The left and right space will be doubled after setting the double width mode.
· The shifting unit is set by the command GS P. The former character space does
not change even if the lateral and vertical units are changed.
· Using the lateral shifting unit under the standard mode.
·Selecting to use the lateral or vertical shifting unit according to the printing area
under page mode.
1
Using horizontal shifting when the beginning position is the top left or lower
right corner of the printing area
②
Using vertical shifting when the beginning position is the lower left or top
right corner of the printing area
The maximum distance of Chinese is36mm.If it is beyond this distance,
taking the maximum distance.
[Default]
n1 = 0, n2 = 0
[Reference]
GS P
FS W n
[Name]
selecting/canceling Chinese double height or width
[Format]
ASCII
FS
W
n
Hex
1C
57
n
Decimal
28
87
n
[Range]
0 ≤ n ≤ 255
[Default]
Selecting/canceling Chinese double width mode
·Cancel Chinese double width mode when the lowest bit is 0
·Select Chinese double width mode when the lowest bit is 1.
[Note]
·only the lowest bit of n is effective.
·To print Chinese dimension under double width mode is the same as to select both
double width and double height.
·The Chinese dimension is printed normally after canceling the Chinese double
width mode.
·When the height of the character in one line is not the same, all the characters
align the baseline
Also using FS! or GS
！
can select or cancel Chinese double height and width mode,
the setting of the last received command is effective.
[Default]
n = 0
[Reference] FS !, GS !
7. Installation and use notes
1. The connection between the paper exit and the paper exit position of the device
suggested to be one of the following figures.
