39
Hex
1D
56
m n
Decimal
29
86
m n
[Range]
①
m = 0, 48, 1, 49
②
m = 66, 0 ≤n ≤255
[Description]
Select one cutting mode and cut paper.
Select cutting mode according to the value of m, as follows:
m
cutting mode
0, 48
Whole cutting
1, 49
half cutting20.
65
Feed paper (cutting p[n*(vertical shifting
unit)inch]) and whole cutting paper.
66
Feed paper (cutting p[n*(vertical shifting
unit)inch]) and half cutting paper.
[Note
①
and
②
]
·This command does effect only at the beginning of line.
[Note
②
]
· m = 0, 48, 1, 49, The printer cuts directly.
· When m=66, the printer feed paper[the distance from printing position to cut +n*(vertical
motion unit)] then cut paper
.·The lateral and vertical shifting unit are set by the command GS P.
·The number of feeding paper is computed by vertical motion unit
GS W nL nH
[Name]
Setting the width of printing area
[Format]
ASCII
GS
W
nL nH
Hex
1D
57
nL nH
Decimal
29
87
nL nH
[Range]
0 ≤ nL ≤ 255
0 ≤ nH ≤ 255
[Description] Setting the width of printing area by nL and nH
·Setting width of printing area to [( nL + nH × 256) × horizontal motion unit)]inches.
[Note]
·This command is just available at the zero position of the line and under
standard mode.
·It is not available under page mode, the printer will handle it as normal data
