IMPORTANT!
The carbon media inside the filter system MUST soak in water for a minimum of
48 hours prior to installation
Carbon Soak Instructions (48 Hours Prior)
Carbon Filter
Tank (Tank 2)
Softener Tank
(FS)
Bypass Valves
(x2)
MNPT Fittings
(x4)
Hose Bib
Assembly
Lawn Hose
Connected to Faucet
This step will require the materials listed below
10) Insert the bypass valve onto
the top of each tank.
11) Fully tighten the fasteners
on both valve connections
securing the bypass valves.
12) Attach and tighten a MNPT
Fitting onto the connections on
each of the bypass valves.
13) Use the hose bib to attach
the lawn hose to the inlet on the
first tank. Ensure the bypass is
off to allow water flow through
the tank.
14) Turn on the water to the
hose halfway until water
exits the tank. Turn off the
water and disconnect the
hose and hose bib.
15) Switch the tank to bypass
and store for 48 hours.
Repeat steps 10-14 with both
tanks.
Bypass Operation
Bypass on, water does
not flow through tank
Bypass off, water
flows through tank
Questions? Call (800)-589-5592
7
Ultra Whole House Well Water Filter System Combo
