FresneLED 250 TW
12
ADVANCED FUNCTIONS
- Colour Test: This function allows to check the
functioning of the led array. The test lasts 5-6 seconds.
- Fan Test: This function allows to check the functioning
of the fan. The test lasts 5-6 seconds.
- Factory Setting: The access to this function is only for
personnel qualified by the manufacturer.
FIRMWARE UPDATE
By switching the luminaire on, the display will show for a
few seconds the number indicating the firmware version
installed.
Should the user wish to install an update in the luminaire
(ex. adding new functions) this can be done though a
suitable interface card (PCB 439 optional) connected on
one side to the DMX Input of the FresneLED and on the
other side to a UBS port of a PC where a programme
will be loaded to INSTALL the new firmware, that can be
supplied by e-mail.
CONNECTION OF MORE FIXTURES
Should more fixtures be used together, they have to
be connected by using the sockets and the 5 poles
XLR plugs on the luminaires and they can have the
following combinations.
DMX CONNECTION
Besides the usual DMX connection with chain
connected luminaires, where the single addresses are
manually assigned, it is possible to set up a DMX auto-
configuration system with the following choices:
• Auto copy:
on the first luminaire of the chain select the
“autoconfig” function and choose from the menu the
“autocopy” configuration to set all the luminaires on
the same DMX address of the first fixture
• Auto patch:
on the first luminaire of the chain select the
“autoconfig” function and choose from the menu
the “auto patch” configuration to progressively get
the DMX free addresses after the one of the previous
luminaire.
CONNECTION OF MORE LUMINAIRES IN STAND
ALONE
The connection of the cables between the first luminaire
and the following ones is the same as per the luminaires
in DMX.
In particular, by selecting the “autoconfiguration”
function all the luminaires after the first one will get the
same configuration of the first fixture.
If the user wishes all the fixtures following the first one
repeat exactly also the intensity and the values of the
various channels as the first fixture it will be necessary
to first select the “master” function on the first luminaire
and then select the “autoconfiguration” function.
In Master / Slave configuration the “silent mode”
function will have the option to enable all the luminaires
to adopt the same function or to disable it via a menu
with “silent disable”.
