FresneLED 250 TW
11
FUNCTIONS DESCRIPTION
Display and Menu (see pictures 6-7-8-9)
All the fixture functions, control modes, options, etc are
performed by using the menu that appears on the rear
display of the luminaire and its 5 buttons.
CCT SETUP
CCT configuration allow the generation of a scale of
whites at different colour temperatures. The enabled
channels are:
- 1 grand master channel (Dimmer) controls the intensity
of the general output
- 1 channel sets the colour temperature levels
- 1 channel adjusts the strobe effect.
CONTROL MODE SETUP
DMX control mode
The DMX control mode allows to control the luminaire
by using a DMX lighting desk.
From the lighting desk it will then be possible to control
and change the following parameters:
•
Master Intensity
: This parameter, also called Dimmer,
proportionally adjusts the light output of the luminaire.
The light output will be adjusted between 0 and 255.
•
Strobe
: This parameter controls the flashing frequency
according to the Master intensity and the relevant
values for each colour. Values 0 and 255 do not make
the luminaire flash; values between 1 and 254 change
progressively the strobe frequency.
•
CCT
: This parameter allows to expand from 3000K to
6500K colour temperature in the white colour area.
RDM control mode
The RDM control protocol uses the DMX line to send/
receive information to/from the FresneLED regarding the
fixture set up, the DMX address, the led temperature, the
software version installed, etc.
The number of functions controlled by the RDM system
depends also on the RDM programme version installed
on the PC used to control the FresneLED or in the control
desk if the function is enabled.
STAND ALONE control mode
The Stand Alone mode allows the fixture to operate
in full autonomy without the use of any digital signal.
Moreover the choice of this mode inhibits the DMX
reception to give space to a possible Master/Slave
connection among more devices.
SILENT MODE
Thanks to the use of a real time feedback of the
temperature inside the Led, FresneLED can control in
a smart way the airflow through the ventilation. Silent
Mode is a function specifically requested whereby a
greater attention to noise absence is necessary. By
activating this function the luminaire will continue
operating in “low noise” mode.
