48
Rear Triangle Reinstallation
1.
To replace the rear triangle, begin by fitting new 1.5 X 18mm inner diameter EPDM o
-
rings onto the
washers as shown. The easiest way to do this is to lay the washer on a flat surface with the flat side
down. Then push the o
-
ring down from the top until it sits in the installation groove:
2.
Insert the upper pivot axles into the link from the inboard side so that they slightly protrude to the
outboard side. Slide the washers, with o
-
rings, onto the ends of the axles from the outboard side:
Summary of Contents for Mayhem 130
Page 1: ...1 MY21 Mayhem 130 Frames Assembly Instructions and Maintenance Manual ...
Page 9: ...9 2 Use the open end of the wrench to turn the adjuster cap 180 Either direction will work ...
Page 54: ...54 Mayhem 130 150 Frame Parts Reference ...
