4
3
2
1
BUS PANEL
BUS PANEL
BUS PANEL
BUS PANEL
5
912-262
912-262
912-262
912-262
the Top Down View for placement.
Bus Panel Plan:
Bus Panel Plan:
Bus Panel Plan:
Bus Panel Plan:
The Bus Panel attach above or below the deck to the
center of the posts with 4 panel attachment brackets. See
INSTRUCTIONS:
INSTRUCTIONS:
INSTRUCTIONS:
INSTRUCTIONS:
MAINTENANCE:
MAINTENANCE:
MAINTENANCE:
MAINTENANCE:
SPECIFICATIONS:
SPECIFICATIONS:
SPECIFICATIONS:
SPECIFICATIONS:
Touch up any marred paint surfaces.
Periodically check hardware for integrity and tightness.
Event: Bus Panel is fabricated of 3/4" polyethylene. Metal
brackets are powdercoated.
Paint shall be electrostatically applied oven cured
powdercoat.
Hardware: Stainless steel tamper resistant.
Sheet 2 of 2
Sheet 2 of 2
Sheet 2 of 2
Sheet 2 of 2
Attach the panel attachment brackets to either side
•
of the panel. Use the panel brackets as a template to
mark, then drill 2 holes through each side of the panel.
Using two people, hold the panel up and attach the
•
brackets to the post with gaskets between the post
and brackets, using the self-tapping screws. The
brackets can be installed without the panel attached
if you mark on the post where the brackets should
be. This can make installation a bit easier.
Install with no
no
no
no more
more
more
more than 3-1/2" between the wall
•
and the nearest edge of the deck. This measurement
is CRITICAL
CRITICAL
CRITICAL
CRITICAL for the safety of the useres.
It is helpful to install with a couple of equal size shims
•
to help hold the wall in position.
