SportsArt Fitness G872, Owner'S Manual, Page: 29 / 74

STEP 16 How to Set the Number of Fitness Products per Pod
Upon setup, the number of fitness products per pod must be entered into the memory
of each product. If this is not done properly, the inverter might get overloaded and its
fuse might break. Details about this procedure are explained below.
A group of fitness products connected to one inverter is called a pod. The number of
fitness products per pod determines the maximum power output per unit. One
inverter can process up to 2000 watts of power. For a maximum of Green System
fitness products, please contact your local distributor.
For pods with eight or more units, the maximum output per product can be calculated
through a simple formula: Divide 2000 watts by the number of fitness products in the
pod. For example, for a ten-unit pod, calculate 2000/10=200. That means that the
maximum power output of each unit in a 10-unit pod is 200 watts. (This is the factory
default setting.) Such power output maximums are calculated automatically, once the
number of units in the pod has been established.
At setup, follow the steps below to enter into each fitness product the number of units
in the pod.
1. Simultaneously press and hold WORKOUT LEVEL
＜▲＞ ＋
WORKOUT LEVEL
＜
▼ ＞ ＋
CHANGE DISPLAY keys for two seconds. This activates the passcode
setting mode.
2. The message screen will show “PASSWORD- 0000”. The passcode 8250 must be
entered before the number of units in the pod can be entered. Follow instructions
below to input the passcode.
a. Use numeric keys 0 through 9 to enter the first digit of the four-digit passcode
8250. After inputting the first digit, 8, press the
＜▼＞
key to confirm your
choice.
b. Then input the next number, 2, followed by the
＜▼＞
key. Proceed in this
fashion until all four digits of the passcode have been entered. If necessary,
press the
＜▲＞
key to return to a preceding entry. Then press the correct
numerical key. After inputting a number value, always press the
＜ ▼ ＞
key to
confirm your choice.
c. After the four-digit passcode has been entered correctly, the product will
automatically enter the units per pod setting mode.
26