SAFETY & WARNINGS
Page 9
Safety & Maintenance
• Make sure all nuts, bolts, and screws are tightened prior
to use.
• Be sure that all adjustment locking devices and safety devices are properly engaged prior to use!
• Never over-tighten the above-mentioned devices and parts to avoid damage to the unit.
• Check for loose parts and components and make proper adjustments prior to use.
• Check to see if there are any tears or bends in the welding or metal prior to use. If tears or bends are found, do
NOT use the unit and contact our CUSTOMER SUPPORT.
• Extreme care must be taken to not allow your feet, fing
e
rs, hair, clothing, and/or any loose items to be snagged
into any portion of the bike when the unit is in motion.
F
ailure to follow these instructions could result in serious
injury, including the loss
of fingers.
• Always wait for the pedals and other movin
g
parts (which can gain great momentum during riding) to come to a c
omplete stop before dismounting the unit to avoid serious
injury.
• Do not use solvent cleaners. If in any doubt, do not use your cleansing product; contact CUSTOMER SUPPORT
MAINTENANCE & CARE
• For any replacement warning labels, please contact our CUSTOMER SUPPORT at (888) 266-6789 or
(909) 598-9876, or mail in a written request to: Hupa International, Inc. 21717 Ferrero Parkway, Walnut, CA 91789.
More detailed information about how to reach our CUSTOMER SUPPORT may be found on Page 1 of the Owner’s
Manual under
the “CUSTOMER SUPPORT” section.
• The specific Parts on your unit which may see possible
signs of wear after prolonged use are listed as follows
(please check these parts before each use):
Seat (#11); Left/Right Pedals (#08/0
9
); Handlebars (#04).
• Please review all safety instructions and warnings in this entire Owner’s Manual, as well as any safety/warning
labels affixed to the product before use.
1. Using one hand to hold
Seat Post (#03)
, unscrew
Knob Bolt (#32)
using the other hand.
2. Slide and adjust
Seat Post (#03)
to the desired hole
setting to your preferred height.
3. Holding
Seat Post (#03)
at this setting, re-insert/re-screw
Knob Bolt(#32)
, ensuring it engages and fully inserts
through the holes of
Shroud Frame (#01)
and
Seat Post (#03).
Please make sure to securely tighten
Seat Post
4. Before sitting on the cycle, press down firmly and pull up slightly on the seat to make sure it is engaged and secure.
HOW TO ADJUST THE SEAT
NOTE:
Always wait for the pedals and other moving parts (which can gain great momentum during riding)
to come to a complete stop before dismounting the unit to avoid serious injury.
1. To reduce speed on the bike, you may use the combinations of your feet on the
to gently and safely apply counter-momentum.
Left/Right Pedals (#08/07)
2. Wait for the flywheel, handlebar, and pedals to com
e
to a complete stop.
3. Now you may safely dismount the unit.
HOW TO (EMERGENCY) STOP
NOTE:
To safely move, transport, and/or store the unit, please seek the help of capable assistants (minimum 2
people total).
1. Position one person on each side of the bike (one on the left, and one on the right).
2. Have each person use the hand closest to the
Seat (#11)
to grip it. Then, grip the other hand from underneath the
respective
Handlebar (#04)
. (These are the safest areas to avoid injury during this process.)
3. Have both people simultaneously lift the unit to move/transport the unit to the desired area.
HOW TO MOVE/TRANSPORT THE BIKE FOR STORAGE
(#03)
but not over-tighten.
XRB358
