54
MAINTENANCE
Lubrication System (Continued)
To replace the lubricant bottle, follow instructions (a) through (d) below.
(a) Loosen the screws on the bezel and push the bezel up.
(b) Take the old lubricant bottle out.
(c) Unscrew the nozzle from the old lubricant bottle and screw it onto new
bottle.
(d) Place the new lubricant bottle into the lubrication system; push the bezel
down and tighten it with screws. (Note: Before place the new bottle
in place, press the pump a couple of times to ensure the lubricant floats
through the hose nicely. Pay attention to the lubricant hose direction
when place the bottle into the system.)
Also note the following:
1. Even if the “Lubricant
bottle exchange” warning is
not displaying, it is still OK
to perform the “Lubricant
change procedure”.
2. After replacing the lu-
bricant, the total lubrication
timer will reset to 0 and start
counting again.
3. After the “Lubricant
bottle exchange” warning
displayed, the lubrication
system will stop lubricat-
ing automatically. The lubri-
cation system will continue
lubricating every 1000km
(621.4miles) after the warn-
ing is cleared.
4. The lubrication system will pump twice automatically once the lubricant
exchanging procedure is completed to ensure the new bottle is working
properly.
(a)
(b)
(c)
(d)
