Sportneer P110M, User Manual

Page: 37 / 38

35
PROBLEM POSSIBLE REASONS SOLUTION
There is no display
on the console.
1. The power cord is not plugged in.
2. Defects on whole set cable or it is
not connected properly.
3. Overload protection.
1. Re-plug the power cord.
2. Plug in every connector well.
3. Ask for a professional technician to reset the
overload protector.
The treadmill belt
is slipping.
1. Running belt is too loose.
2. Motor belt is too loose.
1. Tighten the running belt.
2. Tighten the motor belt.
The running belt is
not smooth.
1. It lacks lubrication oil.
2. The running belt is too tight.
1. Apply lubrication oil to the belt and deck.
2. Loosen the running belt.
The motor does not
work.
1. The safety key is not attached
correctly.
2. The connecting cable of of motor is
not being well connected.
3. The power cord is not well
connected.
4. The invertor is damaged.
5. The motor is damaged.
1. Re-attach the safety key.
2. Ask for a professional technician to well
connect the connecting cable of motor again.
3. Well plug the power cord into a proper power
outlet.
4. Ask for a professional technician to replace the
invertor.
5. Ask for a professional technician to replace the
motor.
ERROR CODE POSSIBLE REASONS SOLUTION
E1
Signal malfunction
1. Communication defects between the
console and the controller.
2. Defective console.
3. Defective controller.
1. Ask for a professional technician to connect the
cable again or replace the cable.
2. Ask for a professional technician to replace the
console.
3. Ask for a professional technician to replace the
controller.
E2
Motor connection
malfunction
1. Motor wire or motor error.
2. The connection wire between the
motor and the controller is defective
or the controller is defective.
1. Ask for a professional technician to replace the
motor.
2. Ask for a professional technician to reconnect
the wire between motor and controller or to
replace the controller .
E3
Speed sensor
malfunction
1. The sensor is installed improperly.
2. Defective sensor.
3. The poor connection wire between
the sensor and controller is
defective.
4. Defective controller.
1. Ask for a professional technician to check and
re-install the sensor.
2. Ask for a professional technician to replace the
sensor.
3. Ask for a professional technician to check and
reconnect the wires.
4. Ask for a professional technician to replace the
controller.
E5
Over-current motor
1. Controller malfunction
2. Motor malfunction
1. Ask for a professional technician to replace the
controller.
2. Ask for a professional technician to replace the
motor.
E7
Safety key signal
malfunction
The safety key falls off. Attach the safety key correctly.
TROUBLESHOOTING