SportDOG SDR-AX, Operating Manual

Page: 10 / 16

10 1-800-732-0144
STEP::06 PROGRAM THE SYSTEM FOR MULTI-DOG
OPERATION
PROGRAM THE SYSTEM FOR TWO OR THREE-DOG OPERATION
(SD-425X, SD-425XS, SD-425XCAMO, SD-825X, SD-1225X)
SportDOG ® Add-A-Dog ® Collar Receiver(s) must be purchased to train additional dogs.
Please refer to "Compatible
SportDOG Systems" chart on page 11 for compatible Add-A-Dog Collar Receivers for these systems.
1. Program the Remote Transmitter to mode 3 or 4 (see page 7).
2. Program the first Collar Receiver.
A. Turn off the Collar Receiver.
B. Press and hold the On/Off Button. The Receiver Indicator Light will come on, then turn off in 4-5 seconds.
If the On/Off Button is released too early, the Receiver Indicator Light will begin its normal flashing. If this
occurs, start over and repeat from A.
C. After the Receiver Indicator Light has turned off, release the On/Off Button.
D. Press and hold the Upper Button on the Remote Transmitter until the Receiver Indicator Light flashes 5
times. If the Receiver Indicator Light does not flash 5 times, start over and repeat from
A.
3. Program the second Collar Receiver using A through D above, but using the Lower Button in place of the Upper
Button.
4. Program the third Collar Receiver using A through D above, but using the Side Button in place of the Upper Button.
PROGRAM THE SYSTEM FOR MULTI-DOG OPERATION
(SD-1825X, SD-1825XCAMO)
SportDOG Add-A-Dog Collar Receivers must be purchased to train additional dogs in two-, three-, or six-dog mode.
Please refer to the chart on page 11 for compatible Add-A-Dog Collar Receivers for these systems.
TWO-DOG OPERATION
SportDOG Collar Receivers can be set to respond to either the
a or b toggle position on the Remote Transmitter.
1. Program the Remote Transmitter to mode 1, 2, 5, 6, or 7 with the toggle in the grey/a position, or any mode with
the toggle in the orange/b position (see pages 8-9).
2. Next, with the toggle switch in the grey/a position, you can now program the first Collar Receiver.
A. Turn off the Collar Receiver.
B. Press and hold the On/Off Button on the Collar Receiver. The Receiver
Indicator Light will come on, then turn off in 4-5 seconds. If the On/Off
Button is released too early, the Receiver Indicator Light will begin its
normal flashing. If this occurs, start over and repeat from A.
C. After the Receiver Indicator Light has turned off, release the On/Off Button.
D. Press and hold the Upper Button on the Remote Transmitter until the
Receiver Indicator Light flashes 5 times. If the Receiver Indicator Light does
not flash 5 times, start over and repeat from
A.
3. To program the second Collar Receiver, repeat steps A through D, but with the
toggle switch in the orange/b position.
TOGGLE SWITCH
SET TO
GREY/a
FOR DOG 1 OR SET
TO ORANGE/b
FOR DOG 2.