20
www.SereneLife.com
IMPORTANT
lf you continue to experience difficulty, please contact our Consumer Service Department for assistance.
LIMITED WARRANTY
Your Pool has been manufactured useing the highest quality materials and workmanship.
All products have been inspected and found free of defects prior to leaving the factory.
This Limited Warranty applies to the
SERENELIFE
Pool only.
This limited warranty is in addition to, and not a substitute for, your legal rights and remedies. To the extent
that this warranty is inconsistent with any of your legal rights, they take priority. For example, consumer laws
across the European Union provide statutory warranty rights in addition to the coverage you receive from
this limited warranty: for formation on EU-wide consumer laws, please visit the European Consumer
Center Website at https://ec.europa.eu/consumers/ecc/contact-en/htm.
The provisions of this Limited Warranty apply only to the original purchaser and are not transferable.
This Limited Warranty is valid for the period noted below from the date of the initial retail purchase.
Keep your original sales receipt with this document, as proof of purchase will be required and must accompany
warranty claims or the Limited Warranty will be invalid. Pool Liner and Frame Warranty-1 Year.
PROBLEM
CAUSE
SOLUTION
PUMP DOESNT WORK
·
Low water level
·
Strainer screen plugged up
·
An air leak on the intake hose
·
Faulty motor or the impeller is
jammed.
·
An air lock inside the cartridge
chamber.
·
Fill pool to correct water level.
·
Clean strainer screens at pool inlet.
·
Tighten hose clamps, check hose for
damage.
·
Clear any sticks or leaves in the intake hose.
·
Open the release valve at top of pump.
TOP COVER LEAKING
HOSE LEAKING
·
Hose clamps are not well-fitted.
·
Hose o-ring dislodged when
connecting the hose.
·
Hose broken.
·
Tighten or change hose clamps.
·
Put the o-ring back into the groove.
·
Replace a new hose.
·
O-ring missing
·
Cover or air release valve are not
tighten.
·
Remove cover & check for O-ring.
·
Tighten cover or valve (Manually).
AIR LOCK
POOL INLET AIR
ADAPTOR/AIR JET
VALVE LEAKING
·
Hose clamps are not well-fitted.
·
Air jet valve is not tight and
facing up.
·
Air jet valve internal seal blocked.
·
Air jet valve internal seal dirty.
·
Air jet valve broken.
·
Tighten or reinstall hose clamps.
·
Tighten air jet valve and make sure it's
facing up.
·
Plug in the pump and run for few seconds,
then unplug, repeat 3 times.
·
Remove air jet valve, flush dirt out with
water and replace valve back.
·
Replace a new air jet valve
There's air trapped in the pump
housing and inlet hose.
Open air release valve, lift and lower the
inlet hose until water starts to flow out of
the air release valve, close air release valve.
