12
www.SereneLife.com
FILTER PUMP EXPOLDED DIAGRAM
P1 Air valve screw
P2 Air valve O ring
P3 Filter housing chamber cover
P4 Filter cover rubber ring
P5 Filter
P6 Body
P7 Seal O ring
P8 Power cable
1. Set up your Storable Pool exactly. Fill it completely with water.
2. Position the filter pump unit at least 8 inches below the highest water level in the pool.
3. And keep the filter pump at lease 2 feet away from the sidewall of the pool.
4. Place filter cartridge into the body of the filter pump.
5. Make certain that the filter chamber rubber gasket is placed in the seal groove on the top of the filter pump.
6. Screw on filter chamber cover onto top of the body of filter pump by hand.
7. Connect the hoses same as the Installation illustration, fixture the pump to the wall of pool.
Remember to use hoseclamp, tighten it secondly with screwdriver.
8. Open both wall plug caps (P13) on the inside of the pool an plug in a strainer (P14) for each.
9. Allow time for filter pump chamber to full with water. Never operate the filter pump dry.
10. Connect electrical power cord into a grounded receptacle protected by a ground-fault circuit interrupter
(GFCI). Please contact a qualified electrician for verification purposes and/or installation of a GFCI
receptacle if necessary.
Please install your filter pump following the lnstallation lllustration bellow:
INSTALLATION ILLUSTRATION
Hose
P8
P8
P7
P7
P10
