6
L-L 283.01-SW
•
In addition to these operating and safety instructions, all accident prevention
regulations as well as any standards relating to the installation and operation of
heaters applicable in your country must be strictly followed.
•
This unit is not intended for use by children. Children must always be supervised
when in the vicinity and ensure that they DO NOT play with the unit. Further, it is not
intended for use by persons with reduced physical, sensory or mental capabilities, or
lack of experience or knowledge.
•
The heater is not to be installed in an area where there is a risk of fire or explosions;
•
Never operate this heater in basements or below ground level because of gas
stagnation.
•
Do not use the heater on floors made with flammable materials.
•
Do not store flammable materials in the vicinity of the heater (minimum distance: 3m);
•
Ensure no overheating of walls, or ceilings made of flammable materials,
•
Ensure all precautions have been taken to prevent fires;
•
Ensure the premises in which the heater is installed are sufficiently ventilated for the
burner requirements; in particular, limits regarding air quality in the room to be heated
must conform to applicable laws;
•
Ensure nothing is obstructing the aspiration and expulsion of air; movement of air may
be obstructed in various ways including placing covers or other objects on the heater
or positioning the heater too near a wall or other large object;
•
Never direct the hot air flow from the heater towards the gas cylinder
•
Ensure the heater is regularly monitored during operation and checked before being
started;
•
Ensure at the beginning of each use, a check is made that the fan moves freely before
plugging the heater into the electrical power supply;
•
Ensure at the end of each use, the mains switch is disengaged and supply power cord
removed, main gas stopcock is closed and gas tube disengaged and sealed.
1. GENERAL ADVICE
The heater must be installed, set up and used in accordance with the applicable
regulations and laws relating to the use of such equipment. Minimum distance from
surrounding walls and/or ceiling: 2m.
2. ELECTRICAL CONNECTION
•
The voltage, hertz rating and number of phases on the data plate
must correspond to that of the electrical mains outlet that the unit is
being connected to.
•
Only connect the unit to electrical installations made by
certified
electricians and in keeping with local electrical regulations and
requirements.
•
It is recommended that the electrical supply to this unit should include either a
residual current device that will interrupt the supply if the leakage current to earth
exceeds 30mA for 30 ms
or a device that will prove the earth circuit.
•
This Class 1 Appliance must only be connected to an earthed power supply fitted with
an appropriately sized fuse.
•
The heater may be connected to a room thermostat by connecting to the thermostat plug
(10). Other accessories such as a timer may also be connected.
3. POWER CORD
•
Make sure before every use that the power cord assembly
is not damaged or cut. If it is DO NOT connect the unit,
