5
e
Glide
Trainer
CG
800
1. Slide the two swing arms (
9
&
10
) onto the console mast axle. There is a left and right swing arm so make sure
you assemble the correct one on each side. Do not force the arms onto the axle or use a hammer as damage
to the bearings could occur. The swing arms have been previously installed at the factory and should fit properly,
although it is a snug fit.
2. Secure the swing arms in place with the stainless steel bolts (
58
) and cup washers (
32
) and tighten. Snap the
decorative caps (
85
) over the cup washers.
3. Attach the foot pedals (
86
left,
87
right) with twelve screws (
59
).
#32.
Cup Washer
#58.
M10 x 20mm
Stainless Steel Bolt
#59.
M5 x 10mm
Phillips Screw
HARDWARE
STEP 2:
Swing Arms & Pedals
