Page 4 of 8
CLEARANCE TO COMBUSTIBLE MATERIALS AND SHELVES
A non-combustible shelf may be fitted to within 150mm of the top edge of the
outlet of the fire. Note that shelves will get hot and delicate ornaments; e.g.
wax candles etc. should be kept away from hot surfaces.
As with all flueless fires the possibility of convection staining on surfaces in the
vicinity above the fire outlet shall be considered and the user advised.
Particular attention should be taken to ensure soft furnishings such as scatter
cushions, rugs and curtains are kept at least 1.5 metres from the appliance.
Material of any description should not be thrown on to the fuel bed.
PREPARING THE APPLIANCE
Unpack the unit. Take the fascia panel and stand this against a flat surface –
Do not lay the fascia flat.
DO NOT ATTEMPT TO USE THE APPLIANCE IF ANY PART OF THE
APPLIANCE IS FOUND TO BE DAMAGED.
FITTING INSTRUCTIONS
•
To get the desired height measure from the floor to the top of the gather.
Place the top of the wall bracket central and 65mm lower than the
gathers height, and mark out the holes. (NOTE – There must be at least
300mm clearance between the floor to the fire opening and 1000mm
from the top of the gather to the ceiling. See Clearances.
•
Drill and plug holes and attach the fixing bracket to the wall.
•
Hang the Enclosure on the wall. In the burner housing section, locate
the two screw holes to the right and left and using two cross-headed
screws secure the burner unit to the wall.
•
Fit and lock the fascia into place by locating two cross-headed screws
through both the fascia and the enclosure situated on each side of the
unit.
•
Once the fire has been fitted and is functioning properly the end user
shall be given these instructions by the installer and advised on the safe
use and maintenance of the fire.
Summary of Contents for Lucent Gel Fire
Page 7: ...Page 7 of 8 DIMENSIONS...
