Spirent communications SmartBits 200, Replacement

Page: 5 / 6

Power Cable/Fuse Replacement
Installing a Chassis Fuse
Power Cable/Fuse Replacement | 5
P/N 340-1228-001 Rev B, 2/03
3 Use the screwdriver again and place it in the slot at the top of the red fuse holder
assembly (
Figure 7 ), then pry the assembly out.
Figure 7. Fuse Holder Assembly Slot Location (SMB-6000B)
4 Slide the fuse holder assembly out of the power supply inlet switch.
5 Locate the fuse that is attached to the side of the fuse holder ( Figure 8 ).
Figure 8. Fuse Location in the Fuse Holder Assembly
6 Remove the fuse and replace it with the international fuse provided in the Power
Cable/Fuse Kit.
7 Replace the fuse holder assembly by sliding it back into the power supply inlet switch
until it snaps into its proper position.
8 Close the cover of the switch until it snaps shut.
9 Connect your new international power supply cable provided in the Power Cable/Fuse
Kit.
Slot
Fuse Holder
Assembly
(slides out)
Power Supply Inlet Switch
(SMB-6000B)
Fuse Location