Power Cable/Fuse Replacement
Installing a Chassis Fuse
Power Cable/Fuse Replacement
|
3
P/N 340-1228-001 Rev B, 2/03
Installing a Chassis Fuse
The installation of a SmartBits chassis fuse varies based on the chassis model. Refer to the
appropriate procedure below to install the fuse for your SmartBits chassis model.
SMB-10, SMB-200, SMB-2000, and SMB-600 Power Supply Inlet Switch
To remove or change a fuse:
1
If your chassis is operating, power down the chassis and disconnect the power supply
cable from its power source.
2
Insert the screwdriver in the fuse holder assembly slot shown in
and pry the
fuse holder open.
Figure 3.
Fuse Holder Assembly Slot Location on the Power Supply Inlet Switch
(SMB-10/200/2000/600)
3
Slide the fuse holder assembly out of the power supply inlet switch.
4
Locate the fuse that is attached to the bottom of the fuse holder assembly shown in
Figure 4.
Fuse Holder Assembly Removed from the Power Supply Inlet Switch
Slot
Fuse Holder Assembly
(slides out)
Power Supply Inlet Switch
(SMB-10/200/2000/600)
Fuse Location
Fuse Holder
Assembly
Summary of Contents for SmartBits 200
Page 6: ......
