SPINNING® STUDIO COMPUTER
OWNER’S MANUAL
www.spinning.com 800.847.SPIN (7746)
11
foam holder
5. Identify the cadence sensor
slot inside the chain guard
(Fig. 6). Insert the cadence
sensor, foam holder and
double stick adhesive into the
slot (Fig. 7).
6. Test synchronization (see
below). Once confirmed,
reinstall the chain guard panel
with the four bolts.
NOTE: To test synchronization,
first press the reset button on the
sensor. Rotate the bike pedals for at
least ten rotations. A green light will
flash after each pass to confirm the
synchronization between the sensor
and magnet.
Sensor Installation, Outside the Chain Guard:
NOTE: This process is for the Spinner® Blade Belt and the Spinner NXT
Black Belt models.
1. Clean the bottom of the chain guard to remove any dust, grease or
grime.
2. Place with right crank arm at the very bottom of the pedal rotation.
3. Lock the flywheel and pedals by turning the resistance knob
clockwise.
Fig. 6
Fig. 7
cadence sensor slot
green light to confirm
synchronization
Summary of Contents for 800.847.SPIN
Page 1: ...OWNER S MANUAL SPINNING STUDIO COMPUTER...
Page 2: ......
