www.spinlock.co.uk
Installation
Installation
16
17
ZS Alloy Jammer
ZS Alloy / Carbon
how to use
pages 8-9
maintenance
pages 22-23
spares
pages 36-37
ZS Carbon Jammer
If fitting to the deck, install the jammers forward of the winch, close enough for easy operation
of the handle and latch, ensuring enough space is left behind the product for removal of the jaw
assembly for maintenance. The jammers are provided with studs (A4-70 stainless steel) in a pattern.
This helps spread the load into lightweight composite decks or masts.
They are a tight fit to ensure good thread engagement. Drilling templates for deck layout are
provided with the product.
Warning : The studs should be screwed a maximum of 15mm into the body. Over tightening
may damage internal bearing surface
Side Mounting :
Replace the six body fasteners with longer bolts. These can be inserted from
either side by removing the round insert nuts. These must be at least A4-70 stainless steel bolts if the
maximum safe working loads are to be reached. Refer to specification chart (page 7).
Double check the hole pattern is correct for the jammer before drilling. The pattern is not
reversible.
Mast Mounting :
Mast mounting plates are available, see page 34 for details. CAD templates
can be download from:
www.spinlock.co.uk/cadlibrary
The Jammers are not designed to withstand high side loads. If the lead angle to the winch is greater
than 10 degrees, fit lead blocks or organisers aft of the jammers. Contact the Special Projects Team
for details of our TSR High Load Aft Organiser.
Spinlock offer ceramic jaw surfaces for specific rope covers and ensure more consistent long term
holding
ZS P-Series Jaws - Anodised jaws designed for use with Dyneema core and Polyester covered lines
ZS HC-Series Jaws - Designed for use with Dyneema core and a cover blend of Polyester with a low
stretch material such as Technora or Vectran. The ceramic surface resists polishing and wear, allows
faster engagement onto loaded line and offers improved load holding.
If fitting to the deck, install the jammers forward of the winch, close enough for easy operation
of the handle and latch, ensuring enough space is left behind the product for removal of the jaw
assembly for maintenance. ZS Carbon Jammers are provided with studs (A4-70 stainless steel) in a
staggered pattern. This helps spread the load into lightweight composite decks or masts.
Warning : The studs should be screwed a maximum of 15mm into the body. Over tightening
may damage internal bearing surface.
They are a tight fit to ensure good thread engagement. Drilling templates for deck layout are
provided with this product.
Double check the hole pattern is correct for the jammer before
drilling. The pattern is not reversible.
Side mounting :
ZS1014B and ZS1618B Carbon Jammers are designed to be bonded.
Mast Mounting :
Mast mounting plates are available, see page 34 for details. CAD templates
can be download from:
www.spinlock.co.uk/cadlibrary
Bonded Mounting :
ZS1014B and ZS1618B are designed for bonding directly onto decks,
spars and booms.
Note: we are unable to provide engineering data on materials and instructions for bonding.It
is essential to refer to your own engineering design data, load data and materials supplier for
guidance.
The Jammers are not designed to withstand high side loads. If the lead angle to the winch is greater
than 10 degrees, fit lead blocks or organisers aft of the jammers. Contact the Special Projects Team
for details of our TSR High Load Aft Organiser.
Warning : Post installation cleaning is essential to avoid jaw set damage, slippage and
possible rope damage on first use. Lubricant is provided. Follow maintenace instructions
on page 22.
Summary of Contents for XX0812/HP
Page 46: ...www spinlock co uk ...
