PulseBlasterESR-PRO-200-cPCI
IDC Headers
Three IDC headers on the PulseBlaster device provide access to all of the output bits. The IDC headers
are labeled Flag0..11_Out, Flag12..23_Out and Flag24..35_Out. On each IDC header, the top row of pins
(pins 14-26) are grounds, and the bottom row of pins (pins 1-13) are signals. The IDC header pinout is shown
in the figure below.
Each pin of an IDC header corresponds to a bit in the Output Pattern and Control field of an instruction
(Each bit corresponds to a channel). The association between bits and pins are shown in the table below.
18
2017/01/24
Figure 10:
IDC header pinout
14 15 16 17 18 19 20 21 22 23 24 25 26
1 2 3 4 5 6 7 8 9 10 11 12 13
Figure 8:
Left: BNC T-Connector and Right: BNC 50 Ohm resistor
Figure 9:
BNC T-Connector on oscilloscope with coaxial transmission line connected on the left
and BNC 50 Ohm resistor connected on the right, to terminate the line.
