19/11/2013
Vers. 1.1
21
Remove the sump by unscrewing all the connecting screws.
9.3.1 Washing the radiator
Once you have removed the protective cover of the sump, before
installing the new filter, you can proceed with the washing of the
radiator if the connection diagram 1 is observed.
If the tool is connected as shown in diagram 2, this must be
excluded.
Place a special oil collector under the sump and, with the cover removed,
press the UP arrow key until you see oil falling from the sump.
The station will start loading oil from the '
Pressure
' pipe and will display
the quantity of oil loaded in the 'New Oil' field (III), while the bar and the
other numerical value (IV) represent the total oil present in the external
tank of the new oil.
Stop the washing when the dropping fluid appears to be cleaned, by
pressing the Down Arrow key.
Thoroughly clean the sump and install the new filter (where possible).
Once the new filter has been installed and the sump has been cleaned, press the UP arrow key and let the ATF
load the oil into the sump with a quantity equal to that removed and displayed in field (I).
Stop the insertion phase by pressing the DOWN arrow key. The quantity of new oil that is being inserted is
indicated by field (III), while field (IV) indicates the total amount of new oil present in the tank.
1
Figure 22 -Removing the oil sump
Figure 23 - Washing the radiator
