19/11/2013
Vers. 1.1
16
8. Connecting the station to the car
Note: What follows may vary depending on the type of transmission you are going to treat.
Connect the ATF to the power supply and turn on the main switch.
The first step is to connect the circuit to the charging
station, with which you can make the process of
emptying and refilling the circuit in an easy way.
To do this, use the right fittings provided.
Unscrew the locking screw of the supporting flange of
the oil pipes and disconnect the delivery pipe of the
lubricant to the oil radiator.
Install the fittings in the output of the delivery on the
gearbox and on the connecting pipe of the gearbox to
the heat exchanger.
Connect the junction duct in the entrance to the gearbox
(1).
Insert the rubber connection in the newly inserted
junction duct (2).
Connect the fitting with the oil delivery pipe to the
radiator (3).
Using the fittings you just placed, connect the pipes
respectively to the output of the gearbox (return) and to
the junction of the heat exchanger (pressure).
Figure 19
– Connecting the station to the car
Figure 20
– Connecting the station to the car (1)
