Operation Manual
–
Spider 2SGS EFI
18 / 55
rev. 01-01-02-2021
5.1 RECOMMENDED METHODS OF OPERATION
This chart shows basic information about recommended methods of cutting grass in various types of terrain. It
also describes the correct procedure of anchoring the hydrostatic stabilizing winch. However current terrain and
climatic conditions may require different methods of operation than those shown in this chart. The operator is
always responsible for choosing the most suitable method of operation especially with regards to safety. In any
case it is always absolutely necessary to comply with all safety instructions listed in this Manual.
Chart of recommended methods of operation is placed together with the basic set of tools on the machine. See
chapter 11.25 Tools
Always jeep the tyres inflated to
the recommended pressure. Other
values may unfavourably
influence the driving
characteristics. Maximum
pressure
– 300jPa/3,0bar/43PSI
Check the blades. Blades must be
properly tightened. Blades must
not be bent and the edges must
not be damaged.
Check the fuel level
Check the overall condition of the
winch. The rope and the snap
hook must not be damaged.
On slopes never enter the area
below or directly above the
machine.
Recommended method of cutting
on slopes up to 36 degrees
provided the operator is well
acquainted with the terrain and
there is no risk of tipping the
machine over.
Recommended method of cutting
on slopes up to 35 degrees
provided the operator is well
acquainted with the terrain and
there is no risk of tipping the
machine over.
On slopes exceeding 36 degrees
always use the stabilizing winch.
On slopes never enter the area
below or directly above the
machine.
Recommended method of cutting
around trees on slopes up to 36
degrees.
Recommended method of cutting
around trees on slopes exceeding
36 degrees. On slopes exceeding
36 degrees always use the
stabilizing winch.
Recommended method of cutting
bushes on slopes up to 36
degrees.
Recommended method of cutting
bushes on slopes exceeding 36
degrees. On slopes exceeding 36
degrees always use the stabilizing
winch.
Recommended method of cutting along roads. Never enter the area
below or directly above the machine. Danger of getting injured by
objects thrown by the blades. Carefully check the terrain in front of the
mower.
Position of important components on the machine (air filter, spark plugs,
hydraulic by-pass allowing the disengagement of hydraulics and
consequent towing of the machine, fuse box, battery, tools)
