Operating Manual
11
1300-87075-1A
Specifications of 2060 Genoseal
Power Supply
115 / 230 VAC, 50 / 60 Hz
Power Consumption
600 watts nominal
Fuse Rating
5 amp anti-surge (T5AH 250 V)
Internal Heaters
4 x 100 watts (sealing plate)
Minimum Plate Height
9 mm
Maximum Plate Height
54 mm
Maximum Sealing Temperature
200 °C
Protection
IP20
Cycle Time (approx.)
10 to 12 seconds (based on a 2 second seal)
Dimensions (depth x width x height)
12.13 in x 8.1 in x 15.3 in (308 mm x 205 mm x 389 mm)
Unit Weight
19.8 lb (9 kg)
Troubleshooting
If the problem with the Genoseal unit persists after the below actions have been carried out, contact Spex for
further investigation.
PROBLEM
ACTION
Genoseal will not power up after
switching on
Check fuse
Foil will not seal properly on a
microplate
1. Check seal temperature and time and reset if necessary
2. Ensure the correct height of plate locators are being used
“Error up switch” is displayed on the
screen after a seal is run
Ensure the correct plate locator/combination is being used and restart
the machine
Poor plate seal in middle of plate
Check if plate supports are required. If required, contact Spex
The unit fails to respond to
commands
Restart the machine
If the problem with the Genoseal persists after the above actions have been carried out, contact Spex for futher
investigation.
