35
This section is used to set the
maximum allowed motor speed
for a given dish.
Tungsten carbide and large
hardened steel dishes should
always be limited to 1050. If you
create a new calibration for
those, make sure the RPM limit
is limited to 1050. All other
dishes can go up to 1200 RPM.
This is used to scroll among
existing calibrated dish entries.
This is used to set the allowed
grinding
speed
deviations,
before an error is thrown.
This has been factory-set
and should not be changed
unless advised by a Spex
service technician.
This section sets the number of
motor steps to confirm the dish
is locked.
This has been factory-set
and should not be changed
unless advised by a Spex
service technician.
This switch is used to put the
instrument in continuous loop.
After a cycle is completed, as
soon as the door is re-closed, a
new cycle will start without
needing to press Start button.
As soon as Stop is pressed, the
Loop switch turns back Off.
Dish calibration
procedure
If you have a dish whose height is not within the standards that existed when the
grinder was manufactured, you can create a new entry for your custom dish. The
same procedure can be done if frequent locking errors appear, due to parts
compression/wear.
1.
With the grinder turned on, insert the desired dish in the grinding location.
2.
Slide the door up until it locks.
