19
ELECTRIC ATTACHMENT CLUTCHES
FIGURE 42
FIGURE 43
VIEW OF BOTTOM
STEP 43: (SEE FIGURE 43)
• Attach the two rear pulley frame brackets (10) to the
inside of the clutch/idler assembly using two 5/16" x 1"
hex bolts (C), eight 5/16" washers (Q) and two 5/16"
nylock nuts (Y) for each bracket.
• Attach the two front pulley frame brackets (12) to the
inside of the clutch/idler assembly using two 5/16" x
3/4" hex bolts (D), 5/16" washers (Q), and 5/16" nylock
nuts (Y) for each bracket.
STEP 44: (SEE TABLE 2)
•
Two different length drive belts are included with
your snow thrower. Use the table below to select
the correct drive belt for your type tractor. The part
number is printed on the outside of the belt .
•
Set aside the belt that is not for your tractor to avoid
accidentally using it.
55" BELT (PART #46989)
TRACTOR TYPE
DECK SIZE
CLUTCH TYPE
56" BELT (PART #48138)
TRACTOR TYPE
DECK SIZE
CLUTCH TYPE
(LT) Lawn Tractor
48"
Electric
(LT) Lawn Tractor
38", 42", 46"
Electric
TABLE 2
STEP 41: (SEE FIGURE 41)
• Turn the clutch idler assembly upside down.
• Hook the long end of the spring (AA) onto the end of
the bolt that extends through the nut on the bottom of
the upper idler arm. Install a 3/8" hex lock nut (Z) onto
the bolt, leaving enough space for the spring to pivot.
FIGURE 41
STEP 42: (SEE FIGURE 42)
• Insert tensioning chains (JJ) through the holes shown
and attach to the springs on the upper and lower idler
arms.
• Install a 3/32" hairpin cotter (GG) in the 5th link of the
chain attached to the upper idler arm.
• Install a 3/32" hairpin cotter (GG) in the 4th link of the
chain attached to the lower idler arm.
3/8" HEX
LOCK NUT (Z)
SPRING (AA)
ATTACH
LONG
END OF
SPRING
HERE
TENSIONING CHAIN (JJ)
(lower idler arm)
TENSIONING CHAIN (JJ)
(upper idler arm)
3/32" HAIRPIN
COTTER (GG)
IN 5th LINK
3/32" HAIRPIN COTTER (GG)
IN 4th LINK
5/16" x 3/4" HEX BOLT (D)
5/16" x 1"
HEX BOLT (C)
5/16" NYLOCK NUT (Y)
5/16"
WASHER (Q)
(4) 5/16" WASHERS (Q)
