11
THIS SECTION IS FOR TRACTORS WITH AN
ELECTRIC ATTACHMENT CLUTCH
STEP 14: (SEE FIGURE 14)
• Turn the clutch idler assembly upside down.
• Hook the long end of the spring (AA) onto the end of
the bolt that extends through the nut on the bottom of
the upper idler arm. Install a 3/8" hex lock nut (Z) onto
the bolt, leaving enough space for the spring to pivot.
FIGURE 14
FIGURE 16
STEP 16: (SEE FIGURE 16)
• Using the lower set of holes attach each rear pulley
frame bracket to the inside of the clutch/idler assembly
using two 5/16" x 3/4" hex bolts (D), 5/16" washers
(Q), and 5/16" nylock nuts (Y).
Use upper set of
holes for Husqvarna TS200 with dual pedals
.
• Using the lower set of holes attach each front pulley
frame bracket to the inside of the clutch/idler assembly
using two 5/16" x 1" hex bolts (C), four 5/16" washers
(Q), and two 5/16" nylock nuts (Y).
Use upper set of
holes for Husqvarna TS200 with dual pedals
.
STEP 15: (SEE FIGURE 15)
• Insert tensioning chains (JJ) through the holes shown
and attach to the springs on the upper and lower idler
arms.
• Install a 3/32" hairpin cotter (GG) in the 5th link of the
chain attached to the upper idler arm.
• Install a 3/32" hairpin cotter (GG) in the 4th link of the
chain attached to the lower idler arm.
FIGURE 15
STEP 17: (SEE TABLE 1)
•
Two different length drive belts are included with
your snow thrower. Use the table below to select
the correct drive belt for your type tractor. The part
number is printed on the outside of the belt.
•
Set aside the belt that is not for your tractor to avoid
accidentally using it.
SELECT THE CORRECT DRIVE BELT
(Electric clutch tractors with a single front deck
suspension bracket)
55" BELT (PART #46989)
TRACTOR TYPE
DECK SIZE
CLUTCH TYPE
(LT) Lawn Tractor
38", 42"
Electric
56" BELT (PART #48138)
TRACTOR TYPE
DECK SIZE
CLUTCH TYPE
(LT) Lawn Tractor
48"
Electric
(GT) Garden Tractor
48", 54"
Electric
TABLE 1
3/8" HEX
LOCK NUT (Z)
SPRING (AA)
ATTACH
LONG
END OF
SPRING
HERE
TENSIONING CHAIN (JJ)
(lower idler arm)
TENSIONING CHAIN (JJ)
(upper idler arm)
3/32" HAIRPIN
COTTER (GG)
IN 5th LINK
3/32" HAIRPIN COTTER (GG)
IN 4th LINK
5/16" x 1" HEX BOLT (C)
5/16" x 3/4"
HEX BOLT (D)
5/16" NYLOCK NUT (Y)
5/16" WASHER (Q)
5/16"
NYLOCK NUT (Y)
(2) 5/16" WASHERS (Q)
STOP
Using the wrong holes will cause belt
misalignment!
