-22-
803235
© Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
Preventative Maintenance
Follow these guidelines to ensure the washer
operates properly. Call for service if you observe any
of the following: water of any amount on the floor,
an increase in operating noise or water remaining in
the wash basket after a cycle.
Control Knob Inserts
Your unit has come equipped from the factory with
a red background on the control panel knobs. If you
wish to change the color, additional color inserts
are included in the accessories bag with your unit.
NOTE: A protective film has been applied to the
color inserts that have been shipped in the
accessories bag. To obtain the best appearance,
remove film before installing inserts.
To add a color insert to the control panel knobs:
1. Pull knob off control panel.
2. Remove and save screws from back side of
knob.
3. Pull off red rear piece from knob.
4. Place desired color insert on top of rear piece,
over the two pegs, making sure flat area of
insert lines up with notch on rear piece. Refer
to illustration.
5. Place rear piece onto front part of knob.
6. Screw knob together with screws removed in
step 2.
7. Reattach knob to control panel.
Frequency
Maintenance Procedure
Monthly
1. Check all hoses and the drain for leaks.
2. Check the door lock for proper operation.
3. Clean the dispenser drawer. Refer to
Using Your Dispenser Drawer
.
4. Check to make sure the washer is level.
Every six months
1. Clean the filter screens in the fill hoses.
2. Clean the door gasket with a bleach and water solution.
Every five years
Have a qualified service technician conduct general preventative maintenance on the washer to ensure it
operates properly.
DRY2236N
Notch on
rear piece of
knob
Flat area of
insert
