26
Multi-device Connection
The figure below is the sketch map of Multi-device interconnection realized by 3 LED
walls. The premise of Multi-device interconnection is the simultaneous communication
between devices. Therefore, the devices should be concatenated to realize a closed loop. The
rear panel of the video processor has two RS232
communication ports: REMOTE TX
(transmission) and REMOTE RX (receiving). Just connect them as shown in the figure.
Processor 1 Processor 2 Processor 3
About Setup and Operation
After the devices are connected, all interconnected devices should be set as follows:
Set Machine No.:
Press the “EXIT/MENU” key to enter the main menu, select
“Advanced” → “Machine No.”, set the desired machine number, and press the “ENTER” key.
(The machine numbers must be different from each other, otherwise interconnection can’t be
realized.)
Set Multi-device Mode:
Press the “EXIT/MENU” key to enter the main menu, select
“ADV” → “Multi-device”, and set the Multi-device Interconnection mode to “On”.
LED WALL
LED WALL
LED WALL
REMOTE TX
REMOTE RX
REMOTE TX
REMOTE RX
REMOTE TX
REMOTE RX
