CHAPTER 7. GNOME-2M
c
OPERATION
If a PIN-code was set (Section 8), you will be requested to enter it as you switch Gnome-2M
c
on. The LCD panel after the first Gnome-2M
c
activation is shown in Fig. 7.1.
Functions of the graphic symbols and terms are listed in Table 6.2. If the inappropriate memory
card format message
”BAD FORMAT”
appears on the screen after switching ”On”, then it is nec-
essary to format the memory card. To do it, install the memory card into the voice recorder or the
special card reader device, connect it to the PC and use OS Windows tools for formatting.
The voice recorder is switched off by pressing and holding (approximately 2 secs) the
key
till the LCD panel switches off.
7.2.3
Setting up and controlling operating parameters
The list of operating parameters (Fig. 7.2) will appear after the voice recorder is switched on and
the
key is pressed. To select a parameter to be edited use
and
. To quit the parameters
menu, press the
key.
Figure 7.2: Setting parameters menu
Using cursor keys (Table 6.1 and Table 6.2), activate necessary voice recorder operating modes
and set required parameter values. Use the
key to enter submenu items, the
key to change
current menu item and the
key to return to higher level menus.
To exit the setting parameters mode without saving, just press the
key several times till the
operating area appears on the screen (Fig. 7.1).
To exit the setting parameters mode and save changes, you should press the
key.
All parameter changes will appear on the screen as symbols representing different modes (see
Fig. 7.3).
Attention!
All voice recorder parameters (except current date and time) are saved in the memory,
independent of the power supply batteries set. Date and time are to be set anew, if the
voice recorder was disconnected from the built-in or external power supply source for
more than one minute.
22
