7.2. PREPARING GNOME-2M
c
FOR RECORDING
Figure 7.1: LCD panel (operating area) when Gnome-2M
c
is switched on for the first time
7.2
Preparing Gnome-2M
c
for recording
Quick preparation
Install the power supply batteries (or plug in the network adapter) and the memory card for quick
recording. The voice recorder is ready to operate with the default settings (stereo recording at 16 kHz
sampling rate without signal compression and masking; auto gain level control is enabled; PIN-code,
date and time are not set).
7.2.1
Standard preparation order
Prepare the voice recorder as follows:
1. Install the power supply (Section 6) or plug in the adapter (Section 6)
2. Insert the memory card
3. Switch on the voice recorder and set current date and time
4. Select operating parameters with respect to sound recording conditions
5. Set new access code (PIN-code) and masking algorithm (if necessary)
6. Connect microphones and headphones (if necessary)
7.2.2
Switching Gnome-2M
c
on/off
To switch Gnome-2M
c
on, install the power supply batteries, memory card, and press and hold
the
key for 1,5 seconds.
After the recorder is switched on, its operating parameters should appear on the LCD screen.
This may take up to three seconds.
21
