9
Press the READ button to read the
probe and update the screen values.
Data values, along with GPS or DGPS
information if applicable, are sent di-
rectly to the data logger. If the logger
searches for, but doesn
’
t find a GPS signal, an error
message will briefly appear in the lower right corner.
In this case, a data point will be stored without the GPS
data. The data point can be cleared from memory with
the DELETE/CLR AVG button (above).
When the data logger is full, the LCD will display the
message
“
Error: Memory Full
”.
To resume normal op-
eration, the logger memory must be cleared using the
Clear Memory
button in Field Scout software (see p.
15)
READ
When the DELETE/CLR AVG
button is pressed and immediately
released, the last data point will be
taken out of the logger file and
removed from the running aver-
age. Pressing and holding this but-
ton will reset the running average but will not affect
data stored on the data logger.
Delete
Clr Avg
Meter Calibration Mode
This mode allows you to calibrate the meter. The cali-
bration procedure is performed in air and distilled water
(see "Meter Calibration", p. 10). Requires firmware v.
6.5 or greater.
CALIBRATION MODE
HIT READ To Cal
Meter Calibration Screen
