0118857R12 Page 4 of 20
From the audience-side of the lectern, position the audience-side
skirt as shown and hook the (2) pre-installed screws into the (2)
keyhole slots in the lectern base.
Figure 3.1, 3.2
.
Figure 3.1
Note: The skirt has been designed to be installed tool-free with the lectern
upright. Do not tip the lectern to install.
The skirt should be removed when the lectern will be moved over long
distances or thresholds to prevent damage to the skirt panels.
3. Install 3-piece skirt
1
2
Figure 3.2
Audience-side skirt
Lectern Base
Keyhole
Slot
Pull the audience-side skirt back (toward audience) to lock the
screws into the keyhole slots.
Figure 3.2
.
Lectern Base
Audience-side skirt
3
Figure 3.4
4
Figure 3.3
Pull side skirt here to
lock into the rotated
keyhole slot
Access from
Instructor-side
Magnet
Position each side skirt as shown and hook the (2) pre-installed
screws into the (2) keyhole slots and move toward the audience-
side to lock in place. The short flat skirt edge should contact the
audience-side skirt, and it should be level with the floor.
Figure 3.3
.
Audience-side
Instructor-side
Pull the instructor-side of the skirt back at an angle to lock the
screw into the rotated keyhole slot. The side skirt should now be
parallel with the lectern base.
Figure 3.3
. Install the magnet as
shown to secure side skirt.
Figure 3.4
. The magnet needs to be
fully-seated and contacting the lectern base.
Pre-installed screw and
rotated keyhole slot
Lectern Base
Side skirt
Pre-installed screw
and keyhole slot
Pre-installed center screw not used
Audience-side view
Side view
Pre-installed screw
and keyhole slot
Pre-installed screw
and keyhole slot
