0118857R12 Page 3 of 20
2. Lectern lift mechanism initial setup,
operation, and reset procedure
Figure 2.1
CAUTION
Keep clear of pinch points during worksur-
face movement. Note: The lift actuators
provide 540 lb of lift.
Figure 2.2
CAUTION
Always unplug the lectern before working under the worksurface. Do not place
anything under the worksurface when operating lift.
Although this lectern utilizes an
anti-collision feature that briefly stops and reverses the worksurface motion in the event
of an obstruction, use caution when raising or lowering.
Do not
sit at, under, or on the
worksurface when operating the lift mechanism and be sure lectern movement does not
interfere with objects or people.
Use caution when raising or lowering the worksurface
!
Preparation:
• Read all instructions before operation.
• Make sure lectern is plugged-in using the 15-foot, 15-amp power cord.
• Locate the “Up” and “Down” control buttons. Control pad is located on the instructor-
side under the worksurface front edge on opposite side from rack cabinet.
• Keep clear of pinch points during worksurface movement.
Normal Operation:
To raise or lower the lectern, press and hold the “up” or “down” arrow keys on the control
pad until the worksurface reaches the desired height. The worksurface can be adjusted
from 32.5”H
(minimum)
to 40”H
(maximum)
.
Control buttons
Down
Up
Note: The lectern has a load-sensing, anti-collision feature
programmed into the controller that actively locks out the
lift mechanisms when unbalanced loads are encountered;
i.e. an obstruction under the worksurface, or weight from a
person sitting on one side of the lectern.
