4mm hex
wrench
Tools Required
Tools Required
Jigsaw
or
Router
Drill
Measuring
device
Pencil
Masking
tape
Drill bit
Overbridge insert panel
(select overbridge lecterns)
0118408 Page 4 of 16
1/4-20 x 35mm
JC bolt
Overbridge
panel
1/4-20 x 35mm
JC bolt
1. To remove the overbridge insert panel, remove the (2) 1/4-20 x 35mm JC bolts with a
4mm hex wrench and lift out the panel.
Figure 5.1
.
2. To make cutouts in the insert panel [optional]:
3. Install controller(s) / electronics into panel.
4. Re-install the overbridge panel and secure with (2) 1/4-20 x 35mm JC bolts.
Note: Blank overbridge panels require the cus-
tomer to make necessary cutouts with a jigsaw
or router. This has a moderate difficulty rating,
so experience and skill with tools is required.
4
mm
1.
Identify all location(s) and sizes for controller(s) or electronics while making sure
all devices fit within the maximum cutout space available in the overbridge panel.
See
Figure 5.2, 5.3
.
2. Locate and mark the exact cutout area(s) on the panel.
Note: Using masking tape on cut lines will minimize laminate chipping while cutting.
3.
Carefully make the cutout(s) in the overbridge panel using a jigsaw or router.
Figure 5.1
