INSTALLATION
2.0
2.0
2.0
2.0
2.0
INTRODUCTION
INTRODUCTION
INTRODUCTION
INTRODUCTION
INTRODUCTION
This section describes the TimeView 400 mounting, switch
setup, connection to a NetClock or computer synchroniza-
tion source and manual set operation.
2.1
2.1
2.1
2.1
2.1
MOUNTING INSTRUCTIONS
MOUNTING INSTRUCTIONS
MOUNTING INSTRUCTIONS
MOUNTING INSTRUCTIONS
MOUNTING INSTRUCTIONS
The ancillary kit includes screws and plastic anchors for
wall mounting the clock. Tools needed for mounting are
a Phillips screwdriver, a ruler, and a 1/4" drill.
TimeView is designed to mount over a duplex outlet to
conceal the power adapter and data cables. For instal-
lations where this is not possible, notches are provided
along the top and bottom edges for routing power and
data cables.
To install TimeView over a duplex outlet, lay a reference
line over the cover plate as shown in Figure 2-1.
To provide clearance for the PS00142 International Power
Supply, locate the left mounting hole 12 inches from the
center of the outlet. Locate the right mounting hole 4
inches from the center of the outlet.
Page 2-1
