Spectra 1759ex, Reference And Installation Manual, Page: 46 / 56

44
R
EFERENCE
& I
NSTALLATION
M
ANUAL
45 User Access Codes (including 1 Duress code)
13.3 DISARMING & DEACTIVATING AN ALARM
To disarm an already armed system or to deactivate an alarm, simply key in a valid access code. Program a designated entry/exit
point, such as the front door or the garage door with an Entry Delay Timer. When these entry/exit point are opened (breached), it
will set off a timer. The system will not generate an alarm until this timer elapses, giving users enough time to enter the premises
and disarm the system. Any user can disarm the system, except users have been assigned the Arm Only Option.
13.4 REGULAR ARMING
This method, commonly used for day-to-day arming, will arm all the zones in the selected partition. If you make a mistake, the
keypad will emit a Rejection Beep. When you have correctly armed the system, the appropriate
ARM
indication will turn on and the
Exit Delay will be initiated. Please note that Regular Arming can also be activated through Auto-Arming, Keyswitch Arming or
One-Touch Arming.
13.5 STAY ARMING
This method allows users to remain in the protected area while partially arming the system. For example, when going to sleep at
night, entry/exit points like doors and windows can be armed while other zones like motion detectors remain deactivated. Please
note that Fire Zones cannot be bypassed.
How Do I Program Access Codes?
1) Press [
ENTER
] .
2) Key in the [
SYSTEM MASTER CODE
] or [
MASTER CODE
] .
3) Key in 3-digit [
SECTION
] (see Table below).
4) Key in new 4- or 6-digit [
ACCESS CODE
] .
[
ENTER
]
flashes. Return to step 3.
How Do I Delete Access Codes?
1) Repeat steps 1 to 3 (see above).
2) Press the [
FORCE
] key once for each digit in the access code (4 or 6 times) until the keypad emits a Confirmation Beep.
Section User Codes
[001] User Code 001 = System Master Code
[002] User Code 002 = Master Code 1
[003] User Code 003 = Master Code 2
[004] to [047] User Code 004 to User Code 047
[048] User Code 048 or Duress Code
How Do I Disarm the System or Deactivate an Alarm?
1) Key in your [
ACCESS CODE
]* .
The arm or alarm indication will turn off and the keypad will emit a Confirmation Beep.
*IF YOU HAVE ACCESS TO BOTH PARTITIONS :
Press the key corresponding to the partition you wish to Disarm or to Disarm both partitions, press the [1] key then after the
Confirmation Beep press the [2] key.
How Do I Regular Arm?
1) Green “
READY
” indicator must be illuminated. Unless the system is partitioned, in which case all zones in the desired parti-
tion must be closed.
2) Key in a valid [
ACCESS CODE
]* .
*IF YOU HAVE ACCESS TO BOTH PARTITIONS :
Press the key corresponding to the partition you wish to arm . To arm both partitions, press the [1] key then after the
Confirmation Beep press the [2] key.
How Do I Stay Arm?
1) All zones in the desired partition (except Stay Zones ) must be closed.
2) Press the [
STAY
] key.
3) Key in a valid [
ACCESS CODE
]* .
*IF YOU HAVE ACCESS TO BOTH PARTITIONS :
Press the key corresponding to the partition you wish to Stay Arm. To Stay Arm both partitions, press the [1] key then after the
Confirmation Beep press the [2] key.