SPECS CCX 70, User Manual

Page: 19 / 40

15
CCX 70
V1.1 | 29 April 2016
Chapter 4 – Operation
The CCX 70 is controlled by the UXC 1000. In addition to switching the water cooling on and off,
the UXC 1000 can display the status of the CCX 70 and allows you to set parameters such as
the water flow and temperature limits.
This chapter contains the basic information relevant to the CCX 70. For more information,
please refer to the UXC 1000 manual.
4.1 Switching On
There is no power switch on the CCX 70—it is switched on by the UXC 1000.
Switching the water cooling on and off is also controlled by the UXC 1000. When you activate a
preset, a valve inside the CCX 70 opens, allowing water flow through the cooling circuits. If you
have a water chiller, this will also be switched on.
To stop the water cooling, use one of the following methods:
Ÿ Press Shutdown on the UXC 1000.
Ÿ
Switch off the UXC 1000.
The Chiller menu enables you to switch the water on and off without starting source oper-
ation—see the following section.
4.2 The Chiller Menu in the UXC 1000
The UXC 1000 uses a menu control system. One of these menus contains information about
the CCX 70. This menu shows the flow rate, temperature and pressure limits as well as the
operating parameters read from the CCX 70.
You can access the chiller menu in the following ways:
Ÿ Switch on the UXC 1000, move the cursor to
Chiller
and press ► to enter the Chiller menu.
Ÿ During operation, press the Menu softkey to enter the main menu and then select the
Chiller menu as above.
There are two softkeys in the menu:
Ÿ
Start
/
Stop
. Activates and deactivates the water cooling. The label on the softkey changes
depending on the cooling status. The State in the infobar shows the current status of the
cooling. This option is not available if the unit is in standby or operating mode.
Ÿ Back . Returns to the previous menu.