Device Management
NVR User Manual
94
12
Device Management
12.1 Network Configuration
12.1.1 TCP/IP Configuration
Click Start
à
Settings
à
Network
à
TCP/IP to go to the following interface.
If the NVR has two network ports or above, you can select the network work pattern as required.
TOE
: It is a technology for improving the network transmission speed. Please enable it according to the actual network situation. If TOE is enabled,
it shall be high speed mode. Then multiple address setting or network fault tolerance can be chosen and configured. If TOE is not enabled, it shall be
compatible mode. Then the network fault tolerance cannot be selected and set up.
Network Fault Tolerance:
The two network ports will be bound to one IP address if you select the “Network Fault Tolerance” pattern. There are many advantages of this work
pattern: 1. increase the bandwidth; 2. form a network redundant array to share the load. When a failure happens to one network port, the other
port will take over the entire load immediately. The takeover process is seamless and the network service will not be broken off.
If “Network Fault Tolerance” is selected, check “Obtain an IPv4 address automatically”, “Obtain an IPv6 address automatically” and “Obtain DNS
automatically” to get the network addresses automatically, or manually enter the network addresses. You can modify the MTU value according to
the network condition (MTU, Maximum Transmission Unit, can be modified according to network condition for higher network transmission
efficiency). Click “Apply” to save the settings.
Multiple Address Setting:
If “Multiple Address Setting” is selected, the IP addresses of the two Ethernet ports should be set respectively. Refer to the picture as shown below.
Check “Obtain an IPv4 address automatically”, “Obtain an IPv6 address automatically” and “Obtain DNS automatically” to get the network addresses
automatically, or manually enter the network addresses; select one Ethernet port as the default route and then click “Apply” to save the settings.
Summary of Contents for N32NRE
Page 124: ...FAQ NVR User Manual 117 Fig 11 2...
