Speck pumpen BADU Jet Smart KH, Operating And Installation Instruction

Page: 36 / 66

36
07.03.2014 TB-b bta badu jet smart_engl.indd
Press knob gasket (26) into jet housing (1) and place against
the back of the pool wall.
Fix the jet housing (1) from the front with the two self-tapping
screws (103) to the pool wall (without liner).
After installing the liner, fix the jet housing with the ten self-tap -
ping screws (52) through clamping ring (28) and clamping ring
gasket (27) to the pool wall.
Attention: Tighten the self-tapping screws only by hand.
Do not use force.
ATTENTION:
The jet housing is made of ABS. If the suction and pressure
tubes are to be glued into the housing when the housing
is already in place, a minimum hardening time of 12 hours
must be observed.
Fitting of the jet housing in liner pools
bta badu jet smart_engl.indd 36 10.03.2014 09:31:01